Eizo MammoDuo RX560 Zusätzliche Informationen Seite 7

●
Adjusting the Screen Height and Angle
Holding both monitors together as in the following figure, adjust the screen height and vertical angle.
Attention
• The tilt lock is locked before shipment. Adjust the vertical angle of the screens after releasing the lock.
• After adjusting the height and vertical angle, pass the cables through the cable holder.
Reference
●
Removing the Monitor
In a case such as when you mount the optional RadiLight on the monitor, remove the monitor unit
from the stand.
Attention
• Removing only one of the monitors from the stand will make the product extremely unstable. Working on
the product in an unstable state may cause the product to topple, which may result in injury or equipment
damage. Be sure to utilize two people.
Remove the monitor unit from the stand after releasing the mount lock.
Note
• Refer to the RadiLight Instructions for Use for information about the mounting procedure.
: Locked,
: Locked, : Released
: Released
5