Starting The Pump - Agilent Technologies Turbo-V 70 PCB Bedienungshandbuch

Starting the Pump

If the forepump and vent device are not operated by the controller,
close the vent valve and switch on the forepump.
With the FRONT panel operation selected, the REMOTE operation is inoperative;
NOTE
conversely, the CYCLE NUMBER and PUMP CURRENT pushbuttons are always
active, even when the operating mode selected is REMOTE.
Press the START pushbutton (or use the remote start signal), and
the display shows:
S
Where the sign minus (-) become a square ( ) when the pump
finish the ramp-up step. The active step is indicated by a flashing
square ( ).
Turbo-V 70 PCB Controller User Manual / 87-900-871-01 (E)
O F T S
[ . . .
Technical Information
T A R T
. . . . .
17
Use
O N
. . ]
259/280