Inhaltsverzeichnis
Werbung
Cleaning the appliance
1. Pull out the mains plug or switch off the
fuse.
2. Wipe the door seal with clear water only
and then wipe dry thoroughly.
3. Clean the appliance with lukewarm
water and a little washing up liquid.
Water for rinsing sold not reach the
lighting. Fig. 1/7.
Note:
Regularly clean the condensation
channel and drainage hole, Fig. q,
so that the condensation can flow out.
Clean the condensation channel with
cotton buds, etc.
The rinsing water must not run through
the drain hole into the evaporation pan.
After cleaning the appliance, re insert
the stopper into the drainage hole for
functional reasons.
Do not use abrasive or acidic cleaning
agents and solvents.
4. After cleaning: reconnect and switch
on the appliance.
Attention!
Never clean the shelves or containers in
the dishwasher. The parts may warp!
Cleaning the cool fresh
space
When cleaning the appliance, all drawers
and telescopic rails can be taken out of
the cool fresh" compartment.
Removing the drawers
Pull out the drawers all the way, lift up and
remove Fig. w.
When inserting the drawers, place them
on the telescopic rails and slide in
(drawers lock onto the telescopic rails).
Taking out the telescopic rails
Fig. e
Pull the locks in the arrowed direction.
Lift the rails and pull out to remove.
To fit the rails, first place in the rear
opening, then in the front opening, then
push down to lock.
Removing the humidity filter
The humidity filter Fig. 1/10 above the
humidity drawer can also be removed.
To do this, first remove the humidity
drawer. Then, lift humidity filter and pull
out.
Lift filter cover Fig. r, remove filter, clean
in luke warm water, allow to dry and
reassemble.
en
31
Werbung
Inhaltsverzeichnis
