Electrical Connection; Wiring Diagram; Structural Prerequisites; Electrical Connection From Below - clage DCX Next serie Kurzanleitung

5. Electrical connection

Wiring diagram

2 1
1. Electronic circuitry
2. Heating element
3. Safety pressure cut-out
4. Terminal strip
5. Safety thermal cut-out
A
Only by a specialist!
Please observe:
• VDE 0100
5
• The installation must comply with current IEC and national local regulations or any
particular regulations, specified by the local electricity supply company
3
• The rating plate and technical specifications
• The appliance must be earthed!
4

Structural prerequisites

• The appliance must be installed via a permanent connection. Heater must be
earthed!
• The electric wiring should not be injured.
• An all-pole disconnecting device (e.g. via fuses) with a contact opening width of at
least 3 mm per pole should be provided at the installation end.
• To protect the appliance, a fuse element with trigger characteristic C must be fitted
with a tripping current commensurate with the nominal current of the appliance

Electrical connection from below

Note: If necessary, the connecting terminal can be displaced to the upper part of the
appliance. If you want to do so, please follow the link below.
Check that the power supply is switched off prior to electrical connection!
1. Dismantle approximately 6 cm off the connecting cable above the wall outlet. With
the smaller opening ahead, slide the water splash protection sleeve over the con-
necting cable so that the sleeve is flush with the wall. This prevents any leaking
water from coming into contact with the electrical leads. It must not become dam-
aged! The protection sleeve must be used!
2. Strip the individual wires and plug them in the connecting terminals according to
the wiring diagram. The appliance must be earthed.
3. Pull the protective sleeve so far over the connecting cables and shape the connect-
ing cables in such a way that the sleeve fits perfectly in the recess of the intermedi-
ate panel without mechanical tension and fix it with the sleeve fixing (A).
Note: Load shedding and electrical connection from below
For further informations please use the online operation and installa-
tion instruction. Please follow the link below or use the QR code via
smartphone or tablet.
https://www.clage.de/links/gma/DCX-Next-GMA-9120-34381
19
CLAGE