Electrical Connection; Wiring Diagram; Structural Prerequisites - clage CEX 9-U Gebrauchs- Und Montageanleitung

CEX 9-U / CEX 9

5. Electrical connection

Only by a specialist!
Please observe:
• e.g. VDE 0100
EN
• The installation must comply with current IEC and national local regula-
tions or any particular regulations, specified by the local electricity supply
company
• The rating plate and technical specifications
• The appliance must be earthed!

Wiring diagram

(fig. E1)
1. Electronic circuitry
2. Heating element
3. Safety pressure cut-out
4. Connecting terminal
5. Safety thermal cut-out

Structural prerequisites

• The appliance must be installed via a permanent connection. Heater must
be earthed! Maximum cable cross section: 6 mm
• The electric wiring should not be injured. After mounting, the wiring must
not be direct accessible.
• An all-pole disconnecting device (e.g. via fuses) with a contact opening
width of at least 3 mm per pole should be provided at the installation end.
• To protect the appliance, a fuse element must be fitted with a tripping
current commensurate with the nominal current of the appliance.
10 mm . .
2 2
15
Electrical connection
Check that the power supply is switched off prior to electrical
connection!
1. Dismantle off the power cable so that you can insert the cable with the
cladding through the water splash protection sleeve up to the cord grip
into the appliance (fig. E2).
2. Lead the cable through the water splash protection sleeve into the appli-
ance so that one can securely fix the cladding of the cable with the cord
grip. If necessary, use one of the three predetermined breaking points for
the cable entry. The protective sleeve prevents water from entering the
appliance alongside the connection line. The protection sleeve has to be
used!
3. Mount the cord grip. The cord grip must be used!
4. Strip the cables and plug them in the connecting terminals according to
the wiring diagram. The appliance must be earthed (fig. E1).
5. After successful electrical connection, fit the hood of the unit. Make sure
not to jam any cables between the appliance hood and the base part of
the appliance (fig. E3).