Portion Programming; Coffee Portion Programming - Fiamma Compass Multiboiler Gebrauchsanleitung

ENGLISH

6. Portion Programming

 The programming of drink portions, hot water and steam temperature works via simulation.
 All settings programmed on group 1 (leftmost group) are automatically transferred to the other
groups. However, it is possible to program each group separately.
 During the programming of one group, all other groups, as well as the water and steam
production, are blocked.
6.1.

Coffee portion programming

It is possible to change the volumetric quantity of the coffee portions as follows:
1. With the machine in ON mode, press key 5 of group 1 (leftmost group) and keep it pressed for 5
seconds. Key 5 starts to blink and the display shows the following message:
2. Within 30 seconds, press the key you want to program, choosing between the 4 keys that
correspond to portions (keys 1-4), for exemple key 1. Pressing the key, drink production starts. Key
5 remains lit during the programming phase.
.
3. When the desired amount of coffee has been produced, press any of the keys 1-4 on the active
group in order to stop the production. The LED of the programmed key turns off, while all other
keys light up.
 In order to program the remaining keys, repeat steps 2-3 (just in case the time of 30 seconds
wasn't been exceeded).
 In case the programming TIME-OUT is activated (after 30 seconds), repeat the3 steps above
described.
 In case a portion can't be saved, check
- If the flowmeter is correctly connected
- If the flowmeter is attributed correctly to the group
- If the water supply is working correctly
Espresso Coffee Machines Compass MB by fiamma
45