Operations; Button Operation; Lcd Panel - PowerWalker VFI 1000 Bedienungsanleitung

3. Operations
3‐1. Button operation
Button Function
o Turn on the UPS: Press and hold ON/Mute button for at least 2 seconds to
o Mute the alarm: When the UPS is on battery mode, press and hold this
ON/Mute Button
o Down key: Press this button to display previous selection in UPS setting
o Switch to UPS self‐test mode: Press ON/Mute buttons simultaneously for
o Turn off the UPS: Press and hold this button at least 2 seconds to turn off
OFF/Enter Button
o Confirm selection key: Press this button to confirm selection in UPS
o Switch LCD message: Press this button to change the LCD message for
Select Button
o Setting mode: Press and hold this button for 5 seconds to enter UPS
o Up key: Press this button to display next selection in UPS setting mode.
o Switch to bypass mode: When the main power is normal, press ON/Mute
ON/Mute + Select
Button
3‐2. LCD Panel
www.powerwalker.com
turn on the UPS.
button for at least 5 seconds to disable or enable the alarm system. But
it's not applied to the situations when warnings or errors occur.
mode.
5 seconds to enter UPS self‐testing while in AC mode, ECO mode, or
converter mode.
the UPS in battery mode. UPS will be in standby mode under power
normal or transfer to Bypass mode if the Bypass enable setting by
pressing this button.
setting mode.
input voltage, input frequency, battery voltage, output voltage and
output frequency. It will return back to default display when pausing for
10 seconds.
setting mode when UPS is in standby mode or bypass mode.
and Select buttons simultaneously for 5 seconds. Then UPS will enter to
bypass mode. This action will be ineffective when the input voltage is out
of acceptable range.
Page 8
EN