Laranzato GREEN Serie Gebrauch Und Instandhaltung Seite 88

● Press the required key within 5 seconds (key 6 Fig.7
of the pushbutton panel set at the technical level),
the steam spout with probe will be activated, the
steam will begin to heat the liquid by conduction
and the temperature will be displayed by the probe
immersed in the liquid.
● On reaching the required temperature, press the
same key again (key 6 Fig.7). At this point the
temperature has been set.
Time programming
Auto ON/OFF (automatically switches on/off): Keep
key E (fig. 7) situated on the first unit on the left
pressed for 5 seconds. Run along the menu by pres-
sing key E until the desired time and day setting has
been reached: to enter the submenu, press key C
(fig. 7). Pressing keys A and B (fig. 7) will increase
or decrease the numeric values to set the time, press
E to confirm.
The same keys will set the day of the week and the
calendar date (day/month/year).
When the time has been set, press E to proceed
to setting the machine's automatic ON/OFF times
and weekly OFF day. One daily ON time and one
daily OFF time which will be valid for every day of
the week.
The parameters for automatic switching ON will be
shown on the display:
Auto ON / OFF
ON : - - . - -
Press E once again and the display will indicate the
parameters for automatic shutdown programming:
Auto ON / OFF
OFF : - - . - -
Press A and B (fig. 7) to increase or decrease the nu-
meric values that set the time. Press E to confirm.
Leaving unvaried the numbers indicating the time,
the automatic ON/OFF function is not set, therefore
the machine
switches on and off manually using the general
switch.
Pressing E once again sets the day and the weekly
shutdown (it is possible to set one only day of shu-
tdown).
The display indicates
Closed On
- - - - - - -
88
Press A and B (fig. 7) to run along the days of the
week. Press E to confirm. If the setting remains
unchanged, day of
shutdown is not programmed.
Consumption, litres, maintenance readings : fol-
lowing the time-setting menu, press E for meter
reading, press C to enter the submenu.
Display indicates
Litres
0 00/00/00
The litres of water used till that moment and the day
of the last updating relative to filter maintenance will
be displayed.
Press E to continue to next display :
Display indicates
Service
0 00/00/00
The number of cycles carried out till that moment
and the date relative to last supplied-coffee signal
maintenance will be displayed.
Press E to continue to next display:
Display indicates
Coffees total
The total number of coffees supplied till that moment
is displayed, a double supply of coffee counts as a
single supply.
Press E to continue to next display :
Display indicates
Epresso Gr.1
The number of espresso coffees supplied from the
first unit till that moment is displayed.
Press E repeatedly to display the totals of each type
of coffee per unit (espresso, coffee, 2 espressos, 2
coffees, continuous).
The next step is reading of the quantity of tea supplied
by each pushbutton panel (1 g, 2 g, 3 g).
Press E again to quit the programming menu.
00
00