Setting The Time - Baxi Luna 3 System HT Gebrauchsanleitung Für Den Verbraucher Und Den Installateur

Figure 3
a) Press either of the
the display will show the letter P followed by a number (program line);
b) press the keys until the display shows P1, referring to the time to be set;
c) press the keys to set the time; on the display, the letter P will start to flash;
d) press the key to save and exit the programming function;
3.3 settIng the maxImum Central heatIng temperature
- Press the key (2-figure 1) to set the central heating water temperature;
- Press the keys to set the temperature required;
- press either of the
note –
With the outdoor sensor probe connected, the
curve. Press the
3.4 – settIng the maxImum DomestIC hot water temperature
- Press the key (3-figure 1) to set the maximum domestic hot water temperature;
- Press the keys to set the temperature required;
- press either of the
3.5– settIng the DaIly program for operatIon In Central heatIng anD DomestIC hot water moDes
3-5.1. setting the daily times for central heating mode operation
- Press either of the
a) press these keys until the display shows
b) press the keys to set the time;
-
press the key; the display will show
- repeat the operations described in points a and b until the third and last cycle is reached
p16
(program line );
-
press the key to save and exit from the programming function.
3-5.2. setting the daily times for domestic hot water mode operation
- As supplied by the factory the appliance is set up with the domestic hot water function always enabled and the domestic
hot water programming function disabled.
The instructions for enabling this program are given in chapter 17, which is addressed specifically to installers (parameter
H91).
If the program is enabled
InstructIons pertaInInG to the user

3.2 settIng the tIme

keys to access the programming function;
keys (1 or 10 - figure 1) to save and return to the main menu.
keys to decrease or increase the room temperature in the premises to be heated.
keys (1 or 10 - figure 1) to save and return to the main menu.
keys to access the programming function;
p11
, referring to the program start time;
p12
, referring to the program end time;
carry out the operations described in point 3-5.1 for program lines
key (2 - figure 1) can be used to shift the central heating
38
31 36
to .
926.423.1 - GB