Audio Setup; Password Setup Page; Digital Output; Parental Control - Clatronic dvd 797 Bedienungsanleitung

Themen Changing the default settings

Audio Setup

Password Setup Page

50
05-DVD 797_GB.indd 50 05-DVD 797_GB.indd 50

Digital Output

Here you specify the settings for the digital Audio output.
All: Output of a digital Audio signal. Use this setting if your amplifi er is no two-
channel stereo amplifi er.
PCM: Output of a digital Audio signal that is converted to a 2-channel signal.
Use this setting if your amplifi er is a two-channel stereo amplifi er.
Off: No digital audio signal is produced.
NOTE:
If there is no Audio output, even though you connected the DVD-Player to an
amplifi er, you will most likely have chosen an incorrect setting for the Audio
output.

Parental Control

Some DVD contain information concerning the target group. This method is
comparable with the rating of cinema fi lms („Suitable only for persons of 12 years
and over" e.g.).
If you have the child lock option activated a probably existing corresponding
information is read from the DVD and compared with the value pre-set by you. If
a DVD is intended for an older age group than the one pre-set by you, the DVD
cannot be played.
The following child lock options are available:
Kid Safe: Suitable for children.
G: Suitable for all age groups.
PG: The presence of parents is recommended. Some scenes may be unsui-
table for children.
PG 13: The presence of parents is strictly recommended. Some scenes may
be unsuitable for children under the age of 13.
PGR: The presence of parents is strictly necessary.
R: Young persons under the age of 17 may only view this fi lm in the presence
of an adult.
NC17: Children and juveniles under the age of 17 are not allowed to watch
this fi lm.
Adult: The fi lm must only be watched by adults.
In order to activate the individual parental control options, please proceed as follows:
1. In the "Parental Control" line press the ENTER key (Fig. 3/13). A window
appears for entering the current password.
2. Enter the current password with the Numeric buttons and confi rm with the
ENTER key. The master password is „8888".
3. Press the ENTER key again (Fig. 3/13).
4. Now select the desired option and confi rm with the ENTER key (Fig. 3/13).
18.08.2008 15:58:27 Uhr 18.08.2008 15:58:27 Uhr