Master ELIPTICAL E30 Benutzerhandbuch Seite 69

Error Message:
E1 (ERROR 1):
Normal state: During workout, when the monitor did not get the count signal from the gear motor more
than 4 seconds and check under successive 3 times then the LCD will show E1.
Power on state: The gear motor will return to zero automatically, when the signal of motor cannot be
detected for more than 4 seconds then the gear motor's driver will be cut off immediately
and show the E1 on the LCD display. All the other digital and function mark are blank,
and the output signals are cut off also.
E2 (ERROR 2): When the monitor read the memory data, if the I.D. code is not correct or the memory IC
damages then the monitor will show E2 immediately at power on.
E3 (ERROR 3): After 4 seconds by start mode, the computer detects the faulty motor did not leave the zero
point then the LCD bar displays "E3".
Technical data of the current adapter
1. Available for Input: 230V/50Hz or 60Hz Output: 6V AC/0.5A
2. Available for Input: 110V/50Hz or 60Hz Output: 6V AC/0.5A
LCD Workout Graphics
PRESET PROGRAM PROFILES:
PROGRAM 1
MANUAL
PROGRAM 4
ROLLING
PROGRAM 7
RAMP
PROGRAM 10
RANDOM
PROGRAM 13
PRECIPICE
PROGRAM 2
STEPS
PROGRAM 5
VALLEY
PROGRAM 8
MOUNTAIN
PROGRAM 11
PLATEAU
72
PROGRAM 3
HILL
PROGRAM 6
FAT BURN
PROGRAM 9
INTERVALS
PROGRAM 12
FARTLEK
EN