O Perating Conditions; P Rotective Devices - SUHNER ABRASIVE UWK 10-R125 Originalbetriebsanleitung

Grinding spindle thread
Sound pressure level EN 60745
Noise emission level
Vibration EN 60745
Weight w/o cable UWK 10-R125
Weight w/o cable UWK 10-R150
Protection class
The specified vibration value was measured with a
standardised test procedure. It can be used to
compare products or to make an initial assess-
ment of the exposure. The vibration emissions may differ
from the specified value, depending on how the power
tool is used. Operating personnel must be protected with
defined safety measures based on the estimated expo-
sure under the actual conditions of use (these must take
into account all phases of the operating cycle, e.g. the
times when the power tool is switched OFF and the times
it is switched ON, but is not under load).
2.4 o
perAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95 % at +10°C not condensed
3.
handlIng
3.1 p
rotectiVe deVices
The machine may only be operated with the safety
guards and the additional handle fitted!
3.1.1 A /d
ssemBly isAssemBly of the sAfety guArd
The bolts and the grooves must align.
M14 / 5/8" Bring the safety guard into the desired working position.
89dB(A), K=3dB For fastening the screw must be tightened down.
100dB(A), K=3dB
2 2
5.2m/s , K=1.5m/s
2.6kg
2.8kg ease, the locking mechanism must be cleaned. Removal
II of safety guard: If necessary, release screw with Allen key.
Bring bolt and groove into alignment and remove the
safety guard.
3.1.2 c
Remove safety guard as mentioned above.
Remove clamping nut and backing flange.
/ o
peratIon
Loosen and remove the three clamping screws.
Carefully remove the spring washer with the three balls,
the drive plate and the washer. Thoroughly clean all parts.
Replace defective parts. Lubricate spring disc ball traveler
with a little multi-purpose grease. Refit all parts in reverse
sequence, making sure that the drive plate and spring
washers are correctly aligned (grooves).
To release, turn screw back approx. ½ rotation.
Safe operation is guaranteed only with tightened
screw. If the cowl can no longer be turned with
leAning of locking mechAnism
21