Specifications; Safety Instructions - Makita 4190D Betriebsanleitung

ENGLISH
1 Set plate
2 Battery cartridge
3 Tank holder installing portion
4 Tank
5 Screw (A)
6 Screw (B)
7 Tank holder
8 Diamond wheel
9 Bolt

SPECIFICATIONS

Model
Wheel diameter .................................................................... 80 mm
Cutting depth
90° ..................................................................................... 0 – 18 mm
45° ..................................................................................... 0 – 16 mm
-1
No load speed (min ) .......................................................... 1,000
Overall length ....................................................................... 313 mm
Net weight ............................................................................ 1.9 kg
Rated voltage ....................................................................... D.C. 9.6 V
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Intended use
The tool is intended for cutting in glass and masonry
materials with a diamond wheel and water.

SAFETY INSTRUCTIONS

WARNING! When using battery operated tools
basic safety precautions, including the following,
should be followed to reduce the risk of fire, leak-
ing batteries and personal injury: Read these
instructions before operating this product and
save these instructions.
For safe operation:
1. Keep work area clean
– Cluttered areas and benches invite injuries.
2. Consider the work environment.
– Do not expose the tool to rain. Keep work area
well lit. Do not use tools in the presence of
flammable liquids or gases.
3. Keep children away
– Do not let visitors touch the tool. Keep visitors
away from work area.
4. Store batteries or idle tools
– When not in use, tools and batteries should be
stored separately in a dry, high or locked up
place, out of reach of children.
– Ensure that battery terminals cannot be
shorted by other metal parts such as screws,
nails, etc.
Explanation of general view
10 Flange
11 Blade stopper pin
12 Tighten
13 Loosen
14 Hex wrench
15 Depth guide
16 Bolt (A)
17 Bevel scale plate
18 Bolt (B)
5.
6.
7.
8.
9.
10. Do not abuse the supply cord (if fitted)
11. Secure the work
12. Do not over-reach
13. Maintain tools with care
19 Blade case
20 Base
21 For straight cuts
22 For 45° bevel cuts
23 Lock-off lever
24 Switch trigger
25 Cap
4190D
Do not force the tool
– It will do the job better and safer at the rate for
which it was intended.
Use the right tool
– Do not force small tools or attachments to do
the job of a heavy duty tools. Do not use tools
for purposes not intended.
Dress properly
– Do not wear loose clothing or jewellery, they
can be caught in moving parts. Non-skid foot-
wear is recommended when working outdoors.
Wear protecting hair covering to contain long
hair.
Use protective equipment
– Use safety glasses and if the cutting operation
is dusty, a face or dust mask.
Connect dust extraction equipment
– If devices are provided for the connection of
dust extraction and collection ensure these are
connected and properly used.
– Never carry the tool by the cord or yank it to
disconnect from the socket. Keep the cord
away from heat, oil and sharp edges.
– Use clamps or a vice to hold the work. It is
safer than using your hand and it frees both
hands to operate the tool.
– Keep proper footing and balance at all times.
– Keep cutting tools sharp and clean for better
and safer performance. Follow instructions for
lubrication and changing accessories. Inspect
tool cords periodically and if damaged have
repaired by an authorized service facility.
4190DB
80 mm
0 –18 mm
0 – 16 mm
1,000
313 mm
1.9 kg
D.C. 9.6 V
5