Frequency Control - Intewa PROFI SC 9-90 Installation Und Betriebsanleitung

2.6 Frequency control

The display consists of a lit display.
This will give you all relevant information such as the current operating pressure, activated
pump, warning messages ect. displayed. Likewise, the desired operating pressure can be
adjusted via the control element.
Note!
On-site frequency control is already set to an operating pressure of 4.0 bar and requires
no further adjustments. However, if the operating pressure is changed, this must be done
within the maximum pump capacity. To change the operating pressure, please observe the
information in the enclosed instructions for the "Speedcenter" frequency control.
fig. 6
Page Seite 31