Inhaltsverzeichnis
Werbung
en
Cleaning the appliance
Before cleaning the appliance, pull out the
mains plug or switch off the fuse!
Wipe the door seal with clear water only
and then wipe dry thoroughly.
Clean the appliance with lukewarm water
and a little washing up liquid. The rinsing
water must not run into the light.
The rinsing water must not run through
the drainage hole into the evaporation
pan.
After cleaning: reconnect and switch on
the appliance.
Attention!
S Do not use abrasive or acidic cleaning
agents and solvents.
S Never clean shelves and containers in
the dishwasher. The parts may warp!
S Regularly clean the condensation
channel and drainage hole, Fig. 9,
so that the condensation can flow out.
Clean the condensation channel with
cotton buds, etc.
34
Cleaning the cool+fresh"
compartment
When cleaning the appliance, all drawers,
the telescopic rails and the humidity filter
can be taken out.
Taking out the drawer
Fig. 0
Pull out drawers all the way, lift at the front
and disengage.
To insert the drawer, place on the
telescopic rails and press down to lock
them into position.
Taking out the humidity filter
The humidity filter, Fig. 1/11, can be
taken out for cleaning. First take out the
humidity drawer, then lift the humidity filter
and pull out.
Lift filter cover, Fig. q, remove filter, clean
in luke warm water, allow to dry and
reassemble.
Taking out the telescopic rails
Fig. w
Pull the unlocking devices in the direction
of the arrow, lift up telescopic rails at the
front.
To fit the rails, first place in the rear
opening, then in the front opening, then
push down to lock.
Cleaning the cold storage
compartment
The pull out carriage can be removed for
cleaning.
For this purpose, pull out the pull out
carriage fully and remove the drawer.
Fig. e
Lift the pull out carriage at the front and
remove. Fig. r
Werbung
Inhaltsverzeichnis
