Peg Perego Viaggio 2-3 SHUTTLE Plus Gebrauchsanleitung Seite 26

and stability in the car, but cannot
replace the function of the car' s safety
belts.
• Surefix fittings guarantee greater safety
and stability in the car, but cannot replace
the function of the car' s safety belts.
• The car seat can be correctly installed
if the operation and maintenance
manual of the vehicle specifies that
it is compatible with "Universal" fixing
systems.
• This child car seat is classified as
"Universal" and meets stricter approval
criteria compared to previous models,
which did not have the approval label.
• The child car seat can only be used in
approved cars, fitted with safety belts
with three static fixing points or winder,
approved under standard UN/ECE R16
or equivalent regulations.
• IMPORTANT: the use of a 2-point seat
belt or lap belt is forbidden.
WARNING
• Carefully read the instructions
before use and keep them in a safe
place for future reference. Failure
to closely follow the car seat
installation instructions will put
your child at risk.
• Viaggio 2-3 Shuttle Plus must be
assembled and installed by adults,
keeping children away from the product.
• When travelling in the vehicle, never
hold your child in your arms or allow
him/her to sit outside of the car seat.
In the event of sudden braking, even
at low speeds, the child might easily be
flung forward.
• Do not insert fingers into the
mechanisms.
• Pay particular attention to luggage
or other objects that could injure the
child sitting in the car seat in case of
an accident.
• Do not use installation methods other
than those recommended because
they could cause the seat to detach.
• Never remove your child from the seat
when the vehicle is moving.
• Never leave your child unattended in
the car seat: watch him even when he
is sleeping.
• Never leave a child alone and
unsupervised in a car, not even for
a short time. The temperature inside
the vehicle can change rapidly and
become dangerous for the child inside.
• Check that the car seat is not blocked
by a moving part of the seat or a door.
• Adjust the height and tension of the
belts, checking that they adhere to the
child's body without being too tight.
Check that the seat belt is not twisted
and the child cannot unfasten it.
• Do not use the car seat without
the lining. This lining cannot be
replaced by other lining that has not
been specifically approved by the
manufacturer because it is an integral
part of the seat and is essential for
safety purposes.
• Do not remove or replace the white
polystyrene part under the seat, in the
backrest and in the headrest, as it is
essential for safety purposes.
• If in doubt, contact the manufacturer
or retailer of this car seat.
- 26 -