Using Headphones In Wired Mode; Putting On The Headphones - Silvercrest SBTH 4.1 A1 Bedienungs- Und Sicherheitshinweise


Then switch on the headphones again and establish the connection with
the 2nd device. For further details, please read the previous section
"Connecting headphones".

After you have established the connection, activate the Bluetooth
of the first device. The connection between the headphones and the first
device is established automatically.

Using headphones in wired mode

Alternatively, you can also connect the headphones (A) to your audio source
with the supplied 3.5mm audio jack cable (C). To do so, insert one end of the
3.5mm audio jack cable (C) into the 3.5mm jack socket (9) and connect the
other end to your audio source. The headphones behave in wired mode like
headphones without Bluetooth
Now adjust the volume directly on your audio source. The buttons on the
headphones (A) do not function in this mode.

Putting on the headphones

Note the markings on the inside of the headband (1) directly above the
loudspeaker (6) to put on the headphones correctly: R = right, L = left. The
controls and the LED (8) are located on the right side of the headphones.
You can adjust the size of the headband (1) by extending the loudspeaker (6)
slightly out of the headband (1) and sliding it back into the headband (1). This
ensures that they fit as comfortably as possible.
®
and can also be used with an empty battery.
SilverCrest SBTH 4.1 A1
®
English - 33
function