Charging The Battery; Using The Headphones - Silvercrest SBKP 1 A2 Bedienungs- Und Sicherheitshinweise

NOTE
Check that the delivery is complete and that there is no visible damage.
If something is missing or damaged, contact the distributor who sold you
this product.

Charging the battery

The battery must be charged prior to first use.
The LED will flash red and headphones sound acoustic signal when the
4
battery is drained. The battery should then be charged as soon as possible.
Plug the micro-USB plug on the charging cable into the micro-USB
12
charging socket on the headphones! Plug the USB plug on the
9 14
charging cable into the USB port on a PC or a USB adapter (not included).
Note: The LED will remain red whilst charging. Once the battery is fully
charged, the LED will remain white.
Once charging has completed, remove the micro-USB plug from the head-
phones.

Using the headphones

Connect the headphones with a communication device.
Place the headphones near a switched on communication device (e.g.
mobile or computer).
To switch on the headphones, press the button for approx. 6 sec-
5
onds, until the LED flashes red / blue in turn and a signal tone sounds.
4
The headphones are now in connecting mode (pairing mode). If the head-
phones do not pair with a suitable playback device within the next
5 minutes, the headphones will switch themselves off automatically.
Now connect your communication device (mobile phone or computer) via
Bluetooth with the headphones. Please refer to the notes in the instructions
®
for your communication device. Select the entry „SBKP 1 A2" from the list
of devices detected by your computer or mobile.
GB 13