Beeps; First Use; Switching The Headphones On/Off - Silvercrest SBTH 4.1 A1 Bedienungs- Und Sicherheitshinweise

Beeps

For specific events, the headphones emit acoustic signals which are indicated
in the following table:
Event
Power-on procedure
Power-off procedure
Pairing completed
®
Bluetooth connection
established
Incoming call
Minimum volume reached
Maximum volume reached
Low battery charge

First use

Switching the headphones on/off

Switch on the headphones by pressing the ▸ll button (2) for approximately 4
seconds. The LED (8) flashes orange and thus indicates standby mode. If the
headphones were switched on for the first time and had never been connected
to a device, pairing mode is started automatically. The LED (8) alternates
between flashing blue and orange in pairing mode. Read the next section
when connecting your device.
Press the ▸ll button (2) for approximately 4 seconds to switch off the
headphones. The LED (8) flashes orange repeatedly when you switch off the
device.
SilverCrest SBTH 4.1 A1
Acoustic signal
Melody
Melody
Melody
Melody
Ringtone
Beep
Beep
4 beeps sound every 20 seconds
English - 31