100 Hour Or Monthly Maintenance; 300 Hour Or Annual Routine Maintenance - Ingersoll-Rand BXR-100H Betriebs- Und Wartungsanweisungen

100 HOUR OR MONTHLY MAINTENANCE

The following routine maintenance must be performed after
every 100 hours of operation or monthly, whichever comes first.
Engine Oil
After the first oil change (20 hours of operation), drain the
engine oil every 100 hours of operation.
Fill with the correct amount of the recommended oil: 0.6 liter for
Honda GX160.
Check the oil level with the oil check gauge.
Fuel Filter Element
Check and clean the fuel filter element after 100 hours of
operation.
V-Belt
Check the tension of the V-belt ( , [Figure 10]) after 100 hours
of operation.
Change the V-belt in case the V-belt is loosened or damaged.
Figure 10
V-Belt Change Procedure
1. Remove the belt cover by removing two bolts.
2. Remove the V-belt by removing five bolts from the V-pulley.
3. Screw one of the five bolts into the closest bolt hole to the
clutch from the taper-color.
4. Replace the V-belt and the remaining four bolts.
5. Tighten all of the bolts. The belt tension is tightened
automatically.
Timing-belt
Check the tension of the timing-belt after 100 hours of
operation.
Adjust the tension of the timing-belt if necessary.
Proper tension is the bend of 10 mm between the pulleys with
load of 6 kgf.

300 HOUR OR ANNUAL ROUTINE MAINTENANCE

The following routine maintenance must be performed after 300
hours of operation or annually, whichever comes first.
Vibratory shaft case oil
Drain the vibratory shaft case oil annually or after 300 hours of
operation.
Remove the drain plug, and the fill plug. Drain out the oil and fill
with the correct amount of the recommended oil.
Timing-belt
Change the timing belt annually or after 300 hours of operation.
14-EN
BXR-100H Reversible Plate Compactors
Operation & Maintenance Manual