10 Hour Or Daily Routine Maintenance - Ingersoll-Rand BXR-100H Betriebs- Und Wartungsanweisungen

Lubrication
Lubrication is an essential part of preventive maintenance,
affecting to a great extent the useful life of the unit. Different
lubricants are needed and some components in the unit require
more frequent lubrication than others.
Specific recommendations of brand and grade of lubricants are
not made here due to regional availability, operating conditions,
and the continual development of improved products. Where
questions arise, refer to the requirements and specifications in
the manufacturer's manual.
All oil levels are to be checked with the machine parked on a
level surface, and while the oil is cold, unless otherwise
specified.
Check Fuel
1. Stop the engine and open the fuel tank cap.
2. Use the automobile unleaded gasoline only.
3. Close the fuel cock before filling the fuel tank.
4. When filling the fuel tank, always use the fuel filter.
5. Wipe off any spilled fuel before starting the engine.
WARNING
Fuel is flammable. May cause injury and property damage.
Shut down the engine, extinguish all open flames and do
not smoke while filling the fuel tank.
Always wipe up any spilled fuel.

10 HOUR OR DAILY ROUTINE MAINTENANCE

It is recommended that the following steps be performed at the
beginning and end of each 8 to 10 hour shift or daily, whichever
comes first.
Engine Oil
Check the engine's oil level at the start of each day and
maintain it to the full mark on the dipstick. Insert the dipstick and
check the full mark on the dipstick. Do not screw the dipstick in.
This will give a false reading. Add engine oil if low. See "100
HOUR OR MONTHLY MAINTENANCE".
Fuel
• Shutdown the engine before filling with fuel.
• Clean the area around the fuel tank cap before removing.
• Fill the tank with unleaded gasoline.
• Do not overfill. The proper level is the red mark on the inlet.
• Clean around the fuel tank cap after filling.
Air Cleaner
If the machine is operating in a dusty environment check the air
cleaner daily. Keep the Air Cleaner Element clean.
To clean the element:
1. Loosen the butterfly nut of the air cleaner cover and remove
the cleaner cover.
2. Check the inner element.
3. Do not wash the inner element since wet type element is
used.
4. Change the inner element if the engine has poor
performance.
5. Install the element into the case and tighten the butterfly nut.
If the air cleaner element is seriously contaminated, the
start-up failure, poor output and malfunctions of the engine
may result.
Fastening Hardware
Check all fastening hardware to ensure it is all adequately
tightened and that none is missing or broken.
BXR-100H Reversible Plate Compactors
13-EN
CAUTION
Operation & Maintenance Manual
EN