Herunterladen Inhalt Inhalt Diese Seite drucken

Long Term Storage - Ingersoll-Rand BXR-100H Betriebs- Und Wartungsanweisungen

Reversierbarer plattenverdichter
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 55
Compactor Operation
1. Shift the THROTTLE LEVER ( , [Figure 5]) to "HIGH"
speed position. This allows the unit to start vibration. Always
operate the unit in the "HIGH" position to avoid damage to
the clutch.
WARNING
When the machine is moving in the reverse direction, the
operator must be to the right or left side of the compactor.
Do not operate from behind the operating handle.
2. Move the direction control lever ( , [Figure 7]) to the
"Forward" or "Reverse" position for the desired direction of
travel and safe speed of travel as determined by conditions.
Figure 7
3. Softly hold the guide bar with two hands without pushing the
plate; let the machine go forward or reverse at its own pace.
4. Changing direction left or right is done by rotating the plate
on itself, using the guide bar as a lever. The unit will rotate
more easily when it is vibrating.
5. Circulate the unit all around the area to be compacted in a
systematic way. Depending on the conditions, three to five
passes might
be necessary
compaction.
CAUTION
Never let the unit go alone as it may result into severe
injuries.
to
obtain
the proper
8-EN
Stopping
CAUTION
Do not stop engine suddenly while running at high speed.
1. Shift the THROTTLE LEVER ( , [Figure 5]) to "LOW"
speed position.
2. Allow the engine to run at low speed for 2-3 minutes before
stopping.
3. Move the throttle lever to the "STOP" position.
4. Turn the ENGINE SWITCH [Figure 2] to the OFF position.
5. Move FUEL VALVE [Figure 3] to the "S" position.

LONG TERM STORAGE

CAUTION
Discharge fuel (No Smoking !)
1. Drain fuel from the fuel tank.
2. Close the fuel cock.
3. Move the operating handle to the verical position and secure
with handle pin ( , [Figure 1]).
4. Clean the unit to remove all dirt, grease, or other materials.
5. Store the unit in a clean dry location. Place a cover over the
unit after it has cooled sufficiently.
CAUTION
Always stop the engine and allow to cool down before
covering the unit.
BXR-100H Reversible Plate Compactors
Operation & Maintenance Manual

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis