Engine Switch; Choke Lever - Ingersoll-Rand BXR-100H Betriebs- Und Wartungsanweisungen

Starting
1. Turn the ENGINE SWITCH [Figure 2] to the "ON" position.
Figure 2
2. Move the fuel valve lever [Figure 3] to the "ON" position.
Figure 3
3. Close the CHOKE LEVER [Figure 4].
If the engine is cold or the ambient temperature is low, close
the Choke Lever fully. If the engine is warm or the ambient
temperature is high, open the Choke Lever half-way, or keep
it fully open.
Figure 4

CHOKE LEVER

CLOSE

ENGINE SWITCH

FUEL VALVE
LEVER
ON
OPEN
4. Position the THROTTLE LEVER ( , [Figure 5]) to "LOW"
speed position.
Figure 5
5. Pull the STARTER HANDLE ( , [Figure 6]) of RECOIL
STARTER slowly until resistance is felt. This is the
"COMPRESSION" point. Return the Handle to its original
position and pull swiftly. After starting the engine, allow the
Starter Handle to return to its original position while still
holding the Handle.
Figure 6
STARTER GRIP
After the engine starts, allow it to run at the low speed and
warm it up without load for about five minutes. Fully open
CHOKE LEVER [Figure 4] gradually.
Avoid fully pulling out the rope. Return the Handle to its
original position.
BXR-100H Reversible Plate Compactors
7-EN
CAUTION
Operation & Maintenance Manual
EN