Cocraft PRO RG500-S Original Bedienungsanleitung Seite 13

Moving the laser level in line projection mode
1. Press [ ] to select a spread angle of 10, 45, 90 or 180°.
2. Press or hold down [ ► ] to move the laser line clockwise.
3. Press or hold down [ ◄ ] to move the laser line anticlockwise.
Raise, lower or incline the laser line
With the laser level set up for horizontal levelling, press [
comes on and Manual Levelling mode is activated.
1. Press [ ] [ ] to incline the laser line.
2. Press [ ] [ ] to raise/lower the laser line.
With the laser level set up for vertical levelling, press [
comes on and Manual Levelling mode is activated.
1. Press [ ] [ ] to incline the laser line.
2. Press [ ] [ ] to move the laser line to the right or left.
3.
Using the laser level with the laser receiver
1. In poor lighting conditions or when used
outdoors, the laser receiver can be used to help
improve detection of the laser line. Mark the line
using the mark on the receiver.
2. Long-press [ ] (47) to illuminate the display
backlight. Long-press again to switch
the display off.
Depth levelling
The picture below shows an example of
how the receiver is used to create a uniform
depth and level surface when digging
trenches and foundations.
When the laser beam hits the sensor
window, the receiver will emit repeated
audible signals. When the laser beam is on
the middle of the line in the sensor window
the receiver will emit a continuous audible
signal.
] so that the green LED
] so that the green LED
13