Cocraft PRO RG500-S Original Bedienungsanleitung Seite 10

Battery holder
1. Insert 4 × C/LR14, 1.5 V batteries (sold
separately). Refer to the markings in
the battery holder to ensure correct
polarity. Never mix old and new
batteries. Never mix rechargeable and
non-rechargeable batteries.
2. Insert the battery holder into the laser
level making sure that the contacts line
up correctly (the battery holder only fits
on in one way).
3. Tighten the lock nut (16).
Remote control
1. Open the battery compartment on the back of the remote control by sliding the cover
in the direction of the arrow and insert 2 × AAA/LR03 batteries (sold separately).
Refer to the markings in the battery compartment to ensure correct polarity.
2. Refit the battery cover.
Laser receiver
1. Release the battery compartment cover
catch and remove the cover.
2. Insert 1 × 6LR61, 9 V battery (sold
separately). Refer to the markings in
the battery compartment to ensure
correct polarity.
3. Refit the battery cover.
10