Parkside PLP 100 A1 Bedienungs- Und Sicherheitshinweise Seite 11

½
Never touch the hot soldering tip or the molten solder.
You could suffer burn injuries. Always let the device cool
before you replace components on the device, clean it
or check its condition.
½
After use let the soldering gun cool down in air only. Under no
circumstances quench the tip in water!
½
When allowing the device to cool or when taking a break from
using it, always stand the device up vertically with the soldering
tip at the top.
½
Keep the device away from combustible materials.
CAUTION! DANGER OF INJURY! Keep your hands away
from the hot workpiece. Avoid contact with the hot soldering tip.
½
If a dangerous situation arises, pull the mains plug immediately
out of the mains socket.
CAUTION! DANGER OF POISONING! Do not breathe air
contaminated with soldering fumes.
½
When working with the device for long periods do not
allow the fumes from soldering to build up. They may
be hazardous to health. Always provide adequate
ventilation of your working area. In addition, it is recommended that
you wear protective gloves, a face mask and a protective apron.
½
Do not eat, drink or smoke in rooms where soldering is carried
out. Otherwise your hands may transfer any adhering traces of
lead via food or cigarettes into your body.
½
Always wash your hands immediately after soldering.
½
Do not dispose of soldering waste with the household rubbish.
Soldering waste must disposed of as special waste.
Safety advice
GB/CY 11