Descaling - Gaggia Milano CLASSIC RI9480 Bedienungsanleitung

ENGLISH

DESCALING

Limescale normally builds up with
the use of the appliance. Use the
GAGGIA descaling product only.
Its formula has been designed to
ensure better machine performance
and operation for its whole operat-
ing life. If correctly used, it also
avoids alterations in the brewed
product. Never use vinegar or other
descaling agents.
Descaling should be performed
every 2 months.
Warning! Never drink the descaling solution or any
products dispensed until the cycle has been carried out
to the end.
1. Insert the filter holder into the brew unit (Fig.1-8) and
turn it from left to right until it locks into place.
2. Remove and empty the water tank (see the chapter
"Cleaning the water tank").
3. Pour HALF the content of the descaling solution into
the water tank and fill it with fresh water up to the
max level.
4. Turn the machine on by pressing the on/off button
(Fig.1-2).
Dispense 2 cups of water (about 150 ml each) from
the steam wand (see the chapter "Preparing hot
water"), and switch off the machine by pressing the
on/off button (Fig.1-2).
5. Let the descaling solution take effect for approxi-
mately 20 minutes with the machine turned off.
6. Turn on the machine by pressing the on/off button
(Fig.1-2).
Dispense 2 cups of water (about 150 ml each) from the
steam wand, switch off the machine by pressing the
on/off button (Fig.1-2) and leave it off for 3 minutes.
7. Repeat the water dispensing described in step 6, until
the water tank is completely empty.
8. Rinse the water tank and fill it with fresh drinking
water.
4219-465-02441 MANUAL GAG. CLASSIC-2019 RI9480 EU V_3.indd 18
9. Place a container under the steam wand. Open the
steam/hot water knob (Fig.1-7) slowly by turning it
counter-clockwise.
Press the brew button (Fig.1-1) and the steam button
(Fig.1-3).
10. Dispense the whole water tank content through the
steam wand. To stop dispensing, press the brew but-
ton (Fig.1-1) and the steam button (Fig.1-3) again and
close the knob by turning it clockwise.
11. Fill the water tank with fresh drinking water.
12. Place a suitable container under the filter holder.
13. Press the brew button (Fig.1-1) and dispense all the
water in the tank. Once the water tank is empty, stop
dispensing by pressing the brew button (Fig.1-1) and
the steam button (Fig.1-3) again. At the end, empty
the container.
14. Remove the filter holder from the unit by turning
it from right to left and rinse it with fresh drinking
water.
15. Repeat the operations from step 8 once again, for a
total of 4 tanks. The machine is now ready to be used.
16. The descaling cycle is now complete.
17. Refill the water tank with fresh water. If necessary,
load the circuit as described in the chapter "Loading
the Circuit".
• 18 •
31/01/2020 12:43:04