Preparing The Product For Use; Switching The Motion Detector On And Off; Setting The Lighting Duration; Adjusting The Sensitivity Of The Sensor - LIVARNOLUX HG04857A Montage-, Bedienungs- Und Sicherheitshinweise

in the manual for the power drill. Death or injury
due to electric shock may otherwise result.
When selecting the mounting location for the
solar cell , pay attention to the following:
12
The solar cell
12
exposed to sunlight as possible. Even partial
shading of the solar cell
can have a significant influence on charging.
Cardinal direction:
Orientation towards the south is optimum. Ori-
entations with slight deviations towards the west
are preferable to those with slight deviations
towards the east.
Horizontal orientation:
The horizontal orientation of the solar cell
depends on the geographic latitude of the
mounting location. In central Europe, and angle
of 30°–40° is ideal.
A mounting plate with 6 drill holes for screws is
located at the back of solar cell
Mount the solar cell
location using the 4 small screws
dowels . Depending on the topography
15
of the mounting location, you can freely
choose 4 of the drill holes in the mounting
plate; however, you should ideally select
2 drill holes on the right and left each (see
fig. B).
Then lay the solar cable plug
nect the plug to the solar electricity socket
of the spotlight
8
The solar cell
12
ing plate via a swivel joint. Orient the solar
cell in a manner that ensures maximum
12
exposure to sunlight.
10 GB
needs to be as directly
during the day
12
12
.
12
at the designated
12
and
13
and con-
14
.
10
is connected to the mount-
Preparing the product
for use
Switching the motion
detector on and off
Press the ON / OFF switch
position to switch on the motion detector
and red LED indicator of ON / OFF
9
switch lights on at the same time.
11
Press the ON / OFF switch
position to switch off the motion detector
and red LED indicator of ON / OFF
9
switch extinguish at the same time.
11

Setting the lighting duration

Turn the rotary control TIME
bottom of the motion detector
to increase the duration of the illumination
(see Fig. C). The lighting duration can be
adjusted within a time window of approx.
5s +/-2s to 5 min +/-1min.
Adjusting the sensitivity of
the sensor
Turn the rotary control SENS
bottom of the motion detector
to increase the sensitivity of the sensor (see
Fig. C).
Note: The motion detector
heat radiation. When outdoor temperatures
are low, it is more sensitive to body heat
than when outdoor temperatures are warm.
Be sure to regulate the sensitivity of the
sensor over the course of the year.
into the ON
11
into the OFF
11
on the
19
clockwise
9
on the
18
clockwise
9
responds to
9