First Use; Aligning The Motion Sensor; Setting Light Time (Time); Adjusting Sensor Sensitivity (Sens) - LIVARNOLUX LLES B2 Bedienungsanleitung Und Serviceinformationen

 Close the cable junction box (3) by screwing the cover again tightly with the four screws that you
previously removed. A rubber seal which is integrated in the cover ensures the sealing of the cable
junction box (3). Ensure that the rubber seal lies correctly in the groove provided in the cover.
 Then attach the energy-saving outdoor spotlight to the wall bracket (6). To do so, use the previously
removed screws (2) and flat washers.
 Switch on the circuit.

First use

Aligning the motion sensor

Make sure that no movements that should not be detected (for example, on the pavements or
streets) occur in the detection range of the motion sensor (8).
It is best if you set the light sensitivity of the motion sensor (8) during the lighting conditions when
the energy-saving outdoor spotlight is supposed to be active.
 Align the motion sensor (8) so that it can capture the desired range as well as possible. The view must
not be obstructed by objects or anything else.
 You can align the motion sensor (8) horizontally by turning it.
 To align the motion sensor (8) vertically, you must first loosen the locking screw (7). If the motion sensor
(8) is located in the desired position, you must tighten the locking screw (7) again.

Setting light time (TIME)

You use the TIME control (15) at the bottom of the motion sensor (8) to set the light time (approx. 1 min to
15 min). Turn the TIME control (15) clockwise (+ direction) to increase the light time or anti-clockwise (-
direction) to reduce the light time.

Adjusting sensor sensitivity (SENS)

You use the SENS control (14) at the bottom of the motion sensor (8) to adjust the sensor sensitivity. Turn
the SENS control (14) clockwise (+ direction) to increase the sensitivity or anti-clockwise (- direction) to
reduce the sensitivity. The higher the sensitivity, the greater the detection range (12 metres at the most).

Adjusting light sensitivity (LUX)

You use the LUX control (13) at the bottom of the motion sensor (8) to adjust the light sensitivity. Here, you
set the lighting conditions to which the twilight sensor responds and thus the energy-saving outdoor
spotlight is switched on or off.
LIVARNO LUX LLES B2
English - 9