Initial Use; Configuring The Lighting Duration; Configuring The Sensitivity Of The Sensor; Configuring The Daylight Level - LIVARNOLUX IAN 316949 Montage-, Bedienungs- Und Sicherheitshinweise

Note: The solar lamp should not be placed near
other light sources such as street lamps or other lamps,
as otherwise, the LEDs will not be able to be switched
on automatically.
Carefully fold the solar panel
snap this into the desired position (see Fig. B).
Loosen the assembly base
light by loosening the screw
using a screwdriver, before pulling the assembly
base downwards (see Fig. C).
4
Mark the drill holes using the holes intended
for the screws in the assembly base
6
Before drilling the fixing holes, ensure there are
no gas, water or electrical lines that could be
drilled into or damaged in the area where you
will be drilling.
Now drill the fixing holes (Ø 6 mm, depth
approx. 40 mm) (see Fig. D).
Insert the dowels
5
(see Fig. E).
Secure the assembly base
provided
(see Fig. F).
6
Now place the LED solar spotlight on the assem-
bly base (see Fig. G). Ensure that the LED
4
solar spotlight is positioned correctly. Ensure that
the solar panel is orientated towards the sun.
1
Screw the assembly base using the screw
Set the ON / OFF toggle switch
position (see Fig. H).
Adjust the individual spotlights horizontally and
vertically until the desired spotlighting is achieved.
The rechargeable batteries will charge when
there is sufficient solar radiation.
The rechargeable batteries need 8–10 hours
in optimal conditions until they are fully charged.
Your lamp is now ready to use.

Initial use

The ON / OFF toggle switch
the "OFF" position for the lamp to switch off.
upwards and
1
from the LED spot-
4
counterclockwise
7
.
4
into the drill holes
using the screws
4
7
to the "ON"
8
must be set to
8

Configuring the lighting duration

Turn the TIME rotary control
increase the lighting duration. The lighting du-
ration can be adjusted within a time window
of approx. 10–60 seconds (see Fig. I).
Configuring the sensitivity
of the sensor
Turn the SENS rotary control
increase the sensitivity of the sensor
Note: The sensor
tion. When outdoor temperatures are low, it is
more sensitive to body heat than when outdoor
temperatures are warm. Be sure to regulate the
sensitivity of the sensor
the year (see Fig I).

Configuring the daylight level

Turn the LUX rotary control
crease the daylight level: In the
sensor only reacts at night (at approx. 5 lx).
2
In the position, the sensor
. at daylight levels, as long as approx. 50,000 lx
are not exceeded (see Fig. I).

Maintenance and cleaning

Do not use solvents, petrol, etc. These will
damage the lamp.
Set the ON / OFF toggle switch
position.
Clean the lamp with a dry, lint-free cloth.
Set the ON / OFF toggle switch
position.
Your lamp is now ready to use.
clockwise to
10
clockwise to
9
.
2
responds to heat radia-
2
over the course of
2
clockwise to in-
11
position, the
also responds
2
to the "OFF"
8
to the "ON"
8
GB 9