Concept VA0010 Bedienungsanleitung Seite 44

DESCRIPTION OF THE DEVICE
1. Safety switch
2. Lid buttons
3. Suction opening
4. Sealing strip
5. Vacuum chamber
6. Bottom gasket
7. Top gasket
8. Sealing element
OPERATING INSTRUCTIONS
The process of production of bags from Concept Fresh rolls - VB2203, VB2806
1. Connect the unit to the mains.
2. Unwind a section of the foil you will need for storing of your food and cut it off with scissors, adding approx. 10
cm in length to allow for sealing and bag shrinkage (Fig. 1). If you wish to reuse the bags, add about 1.5 cm for
each use so that the bag can be resealed after cutting off the seal. Both ends are to be cut perpendicular to the
longitudinal edge of the roll.
3. Open the lid of the unit and insert one of the cut edges into the unit, so that the edge of the foil touches the gasket
of the seal vacuum chamber (6). The bag must not overlap into the vacuum chamber (5) (Fig. 2).
4. Close the lid and press it down firmly on both sides (Fig. 3). The unit turns on when snapped shut. Once the bag
is sealed, the unit automatically turns off. Open the lid by pressing the grey buttons on the sides of the appliance
(Fig. 4).
Fig. 1
42
6
Fig. 2
8
5 4
Fig. 3
EN
7 1
3 2
Fig. 4
VA0010