Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Frequently asked
EN
Why is there a delay before the drink is dispensed?
The machine is adjusting to the right temperature to make your beverage.
questions
After using the milk pod, why is the drink not dispensing immediately after pressing the Espresso or Brewed buttons?
After a milk pod, the machine requires 8–10 seconds to heat to the required temperature. Push Espresso (top) button. Wait until lights stop
flashing, then push Espresso (top) button again.
How do I remove the pod container if it is jammed or overfilled?
Gently move the pod container back and forth while removing the container.
Why is the beverage not hot enough?
The machine may need to be descaled (refer to section "Descaling the Machine").
Why are all the buttons flashing at a fast rate for a prolonged period of time?
Try switching off the machine and unplugging the plug from the wall socket. If this problem persists, please visit Verismo.com.
Why is the drink not dispensing properly?
Ensure the lever is pressed down completely. If necessary, descale the machine (refer to section "Descaling the Machine").
Designed for beverage pods that bear the
Why does the machine switch itself off suddenly when it is used a lot?
Verismo™ System logo. Also compatible
The machine switches itself off as protection against overheating. If this occurs, let the machine cool down for about 30 minutes before using
with other K-fee® System pods.
it again.
If any problems persist, contact Verismo.com
Emptying the
EN
Empty the residual water if the appliance needs to be transported or stored during frosty conditions (temperatures below 0°C). This prevents
machine
residual water from freezing inside the appliance.
Let appliance warm up to room temperature if necessary. Make sure that the appliance is switched off. Open lever and close it again. Remove
and empty the water tank. Press the Espresso and Milk buttons at the same time, hold them and press the Power button for at least three
seconds. Evaporation will start. Wait until evaporation is finished. Reinsert empty water tank. Wipe and dry the front of the appliance with
a cloth.
WARNING
WARNING: Extremely hot water
The steam temperature can be as high as 120°C. Do not reach under the spout and keep at a safe distance from spout.
WARNING: Extreme temperatures
• Protect the appliance against frost.
• Do not operate the appliance above 45°C to avoid damaging the appliance (temperature range for operation is 10–45°C).
• Do not operate the appliance below 10°C to avoid damaging the appliance (temperature range for operation is 10–45°C).
16
Telephone Numbers:
220 – 240 V, ~ 50 Hz, maximum 1455 W
United Kingdom:
Germany:
1 m
France:
Austria:
P
Switzerland:
ressure
Maximum pressure 275 psi
1 L
3.8 kg
A = 150 mm
C
B = 378 mm
A
C = 297 mm
B
Maximum 150 mm
max
min
10°C–45°C
Approximately 90°C
This appliance bears the sign for waste electrical and electronic equipment "WEEE" in accordance with European Directive 2002/96.
Most WEEE is disposed of with general waste. Directive 2002/96 requires member states to minimise the amount of WEEE which is
disposed of as general waste and to achieve a high level of separate collection of WEEE. Separate collection means that WEEE can be
recycled and this saves energy and resources and avoids hazardous materials going to landfill. The crossed-out wheelie bin symbol
means that you should not dispose of this machine in your dustbin with your general waste. You should dispose of this machine separately.
In helping to separately collect WEEE you will be playing a key role in ensuring that recycling takes place and thereby help to improve the
environment. You should dispose of this equipment at your public recycling facility.
Specifications
+44 (0) 208834 5050
+49 (0) 89 551 555 500
+33 (0) 144767300
+43 (0)800 330033
+41 (0)800 220066
Disposal
instructions
EN
EN
17
Werbung
Inhaltsverzeichnis
