Installation - LIVARNOLUX HG05423 Montage-, Bedienungs- Und Sicherheitshinweise

Before installation ensure that the circuit, to which the product will be
connected, is not energised. To do so, remove the fuse or switch off the
circuit breaker in the fuse box (0 position).
Use a voltage tester to verify the de-energised status.
The included mounting material is suitable for ordinary solid concrete
or masonry construction. Check which mounting material is suitable
for your chosen mounting surface. If necessary, seek expert advice.

Installation

Make sure you will not be drilling into electrical, gas or water lines inside
the wall. Use a power drill to drill the holes into the brick wall. Always ob-
serve all safety instructions for the power drill in the ma nual for the power
drill. Death or injury due to electric shock may otherwise result.
When selecting the mounting location, pay attention to the following:
Select a sturdy and vibration-free wall.
Keep a minimum distance of approx. 20 cm to other objects to ensure
a good ventilation.
Only mount the product in one direction. The "UP" label on the
product resp. the arrow should be pointed upwards (see Fig. D).
Make sure that the LED spotlight
You can move the product vertically to adjust the angle.
Make sure the motion sensor
sensor has a maximum coverage range of 8 m, with a coverage
1
angle of about 160 ° (depending on the mounting height – a height
of 1.80–2.50 m is ideal).
Make sure the motion sensor
lighting. This can influence its functioning.
Don't adjust the motion sensor
where animals could be easily detected. Do not adjust the motion
sensor to fan heaters, air conditioners, pools or other objects with
1
fast-changing temperatures.
Use the bracket
wall. Ensure that there are no cables or wires in this area in the wall.
12 GB/IE/NI
2
covers the desired area. The motion
1
is not illuminated at night by street
1
1
as a pattern to mark the drilling holes onto the
4
illuminates the desired area.
onto trees, bushes or locations