simu T5ZSP Originalanleitung Seite 7

1
0.55 Nm
±0.1
SET UP
2
During the end limits adjustment, there is a one-second delay in motor operation.
2.1. Connect the motor to the
setting switch (ref.: 9025462).
2.2. Check the rotation direction:
Connect the switch to the mains, then press ▲:
a. If the tube turns in the "up" direction, go
to step 2.3.
b. If the tube turns in the "down" direction,
invert the brown (2) and black (3) wires on
the motor, and repeat the test.
2.3- End limit adjustment: The procedure used to set the end limits depends on the equipment of the
product (see table below):
Top stop
-
SETTING 1: MANUALLY SETTING THE UP AND DOWN END LIMITS
1 2
≥ 3 s ≥ 3 s
>>
1- Press on ▲/▼ for 3 seconds. The motor will run briefly in one direction and then in the other*.
2- Press on ▲ for 3 seconds. The motor will run briefly in one direction and then in the other*.
3- Position the product on the desired up end limit using the ▲ and ▼ keys.
4- To memorize the up end limit, press ▼ twice, as follow:
- 1st press for 0,5 second without the motor rotation.
- 2nd press over 3 seconds, so the motor rotates briefly one way, then in the other*.
5- Position the product on the desired down end limit using the ▲ and ▼ keys.
6- To memorize the down end limit, press ▲ twice, as follow:
- 1st press for 0,5 second without the motor rotation.
- 2nd press over 3 seconds, so the motor rotates briefly one way, then in the other*.
7- Press on ▲/▼ for 3 seconds. The motor will run briefly in one direction and then in the other*.
After the operation 7, the settings are completed. There is no delay time any more. Go to stage §3.
* Press the buttons until the motor turns into the two directions.
> 15 Nm & ALUMINIUM WHEEL
9910004
5
9910004
2
3
Setting to
Heavy load
performe
bar
- See setting 1
- See setting 2
See setting 3*
3
>> >>
Ø4,8x10
STEEL
Ø5 x 10
4
Plastite FXS N7\7x12 Zing
PE
L
N
a
OK
>>
*This setting is
especially suitable
for "ZIP screens" or for
any other specific driven
product with a heavy load
bar and a top stop.
4 5
0.5 s ≥ 3 s
+ >>
6 s max.
20 Nm max.
9910013
9001528
Plastite FXS N7\7x12 Zing
T5ZSP / T5ZSP RH
b
>>
6
0.5 s ≥ 3 s
>> +
6 s max.
25 Nm max.
9910014
Blue
Brown
Black
Green / Yellow
7
≥ 3 s
>>
EN
2/5