Important Safety Instructions - Makita AN250HC Bedienungsanleitung

The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
13th March 2009
000230
Tomoyasu Kato
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, JAPAN
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED TO REDUCE THE RISK OF PERSONAL
INJURY, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
1. For personal safety and proper operation and
maintenance of the tool, read this instruction
manual before using the tool.
2. Always wear safety glasses to protect your eyes
from dust or pin injury.
WARNING:
It is an employer's responsibility to enforce the
use of safety eye protection equipment by the tool
operators and by other persons in the immediate
working area.
3. For Australia and New Zealand only
Always wear safety glasses and face shield to
protect your eyes from dust or pin injury. The
safety glasses and the face shield should conform
with the requirements of AS/NZS 1336.
WARNING:
It is an employer's responsibility to enforce the
use of safety eye protection equipment by the tool
operators and by other persons in the immediate
working area.
Director
Safety glasses
Face shield
000114
4. Wear hearing protection to protect your ears
against exhaust noise and head protection. Also
ENB115-1
wear light but not loose clothing. Sleeves should
be buttoned or rolled up. No necktie should be
worn.
5. Rushing the job or forcing the tool is dangerous.
Handle the tool carefully. Do not operate when
under the influence of alcohol, drugs or the like.
6. General Tool Handling Guidelines:
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
7. An improperly functioning tool must not be used.
8. Sparks sometimes fly when the tool is used. Do
not use the tool near volatile, flammable materials
such as gasoline, thinner, paint, gas, adhesives,
etc.; they will ignite and explode, causing serious
injury.
9. The area should be sufficiently illuminated to
assure safe operations. The area should be clear
and litter-free. Be especially careful to maintain
good footing and balance.
10. Only those involved in the work should be in the
vicinity. Children especially must be kept away at
all times.
11. There may be local regulations concerning noise
which must be complied with by keeping noise
levels within prescribed limits. In certain cases,
shutters should be used to contain noise.
12. Do not play with the contact element: it prevents
accidental discharge, so it must be kept on and
not removed. Securing the trigger in the ON
5
Always assume that the tool contains
fasteners.
Do not point the tool toward yourself or
anyone whether it contains fasteners or not.
Do not activate the tool unless the tool is
placed firmly against the workpiece.
Respect the tool as a working implement.
No horseplay.
Do not hold or carry the tool with a finger on
the trigger.
Do not load the tool with fasteners when any
one of the operating controls is activated.
Do not operate the tool with any power
source other than that specified in the tool
operating/safety instructions.