Maintenance - Makita AN250HC Bedienungsanleitung

Cutting off the sheet
CAUTION:
Always disconnect the hose before cutting off the
•
sheet.
Fig.16
Tear off the output sheet in the direction of the arrow
when using the sheet collated pins.

MAINTENANCE

CAUTION:
Always disconnect the air hose from the tool before
•
attempting to perform inspection or maintenance.
Jammed nailer
CAUTION:
Always disconnect the air hose and remove the
•
pins from the magazine before cleaning a jam.
Fig.17
Fig.18
When the nailer becomes jammed, do as follows:
Open the magazine cap and remove the pin coil. Insert a
small rod or the like into the ejection port and tap it with a
hammer to drive out the pin jamming from the ejection
port. Reset the pin coil and close the magazine cap.
Drain tool
Fig.19
Remove the hose from the tool. Place the tool so that
the air fitting faces down to the floor. Drain as much as
possible.
Cleaning of tool
Blow off dust adherent to the tool by using an air duster.
Cap
Fig.20
When not in use, disconnect the hose. Then cap the air
fitting with the cap.
Storage
When not in use, the nailer should be stored in a warm
and dry place.
Maintenance of compressor, air set and air hose
Fig.21
Fig.22
After operation, always drain the compressor tank and
the air filter. If moisture is allowed to enter the tool, It
may result in poor performance and possible tool failure.
Check regularly to see if there is sufficient pneumatic oil
in the oiler of the air set. Failure to maintain sufficient
lubrication will cause O-rings to wear quickly.
Fig.23
Keep the air hose away from heat (over 60°C, over
140°F), away from chemicals (thinner, strong acids or
alkalis). Also, route the hose away from obstacles which
it may become dangerously caught on during operation.
Hoses must also be directed away from sharp edges
and areas which may lead to damage or abrasion to the
hose.
Thinner
004320
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Pins
•
Air hoses
•
Safety goggles
•
9
Stove
or attachments
Only use accessory or
are