Battery Insertion; Connections - Compex runner Anweisungen

EN

BATTERY INSERTION

Open the battery compartment cover and insert the battery, with the label pointing upwards so that the + and - terminals are
opposite the device's contacts. Then replace the cover. If the device is not going to be used for over 3 months, ensure that the
battery is fully charged. If the device is not going to be used for over 6 months, ensure that the battery is fully charged and
remove it from the stimulator. Switch the stimulator off before removing the battery.

CONNECTIONS

CHARGER CONNECTION
COMPEX
Remove all stimulation cables from the stimulator before recharging it. Connect the charger to a wall socket and connect the
stimulator by sliding the red cover to the right to reveal the charger connector. It is strongly recommended to fully charge the
battery before its first use to improve its performance and life span.
CONNECTING THE CABLES
The cables of the stimulator connect to the 4 sockets at the front of the device. The MI-sensor cable can be connected to any
socket on the stimulator.
COMPEX
08