Changing Attachments; Commissioning; Working Notices; Switching On / Off - Parkside PES 200 B1 Originalbetriebsanleitung

Before taking tool into use / Commissioning
The supplied accessories are suitable for the most
widespread areas of application (see Figs. C, D, E,
F and G).
Knife / Scraper attachment (offset)
5
Knife / Scraper attachment (straight), e.g. for
6
removing carpets, felts, cork sheets as well as
plaster and adhesive residues (see Fig. C, E)
Spatula attachment (flat), e.g. for removing
7
paint residues, silicon and foams (see Fig. D)
Chisel attachment (flat), e.g. for carving soft
8
woods (see Fig. F)
Carving chisel (13 mm), e.g. for carving in
9
softwoods (see Fig. G)

Changing attachments

Q
Wear suitable protective gloves when
inserting and testing attachments tool
Notice: The curve / working edge of the attachment
tool must always point downwards.
4
Inserting a tool attachment:
P ush the tool lock
I nsert the attachment tool
in the tool receptor
P ush the tool lock
the tool attachment is locked.
Removing a tool attachment:
P ush the tool lock
R emove the inserted tool attachment
the tool receptor
3

Commissioning

Q

Working Notices

Q
A lways work away from the body.
H old the appliance with both hands (see Fig. B).
I ntroduce the attachment tool
or the area to be worked with the appliance
switched on. In that the working motion of the
appliance first takes place on contact with the
10 GB/IE
forwards to "UNLOCK".
2
as far as it will go
4
(see Fig. A).
3
backwards to "LOCK" -
2
forwards to "UNLOCK".
2
from
4
.
to the material
4
material, you will achieve a much more accu-
rate positioning of the attachment tool.

Switching ON / OFF

Q
Notice: The working motion of the appliance first
takes place on material contact.
Switching on:
P ush the ON / OFF switch / Stroke rate prese-
lector forwards.
1
Switching off:
P ush the ON / OFF switch / Stroke rate prese-
lector backwards.
1

Selecting the stroke rate

Q
.
4
Note: The optimal stroke rate is dependant on
the material or the surface to be worked. It is best
determined by simple trial and error. Always start
off with the lowest setting. Should the removal be
too slight, increase the stroke rate level for level.
S lide the ON / OFF switch / Stroke rate prese-
lector to the front to increase the stroke rate.
1
Level 1: low stroke rate for precision work
Level 2: moderate stroke rate
Level 3: highest stroke rate for fast removal
S lide the ON / OFF switch / Stroke rate prese-
lector to the rear to decrease the stroke rate.
1
Resharpening the
Q
attachment tools
The best work results are only achieved with sharp
attachment tools. You should thus resharpen them
in good time.
the plug from the power socket before beginning
to sharpen the tools.
RISK OF INjURy! Remove