YATO YT-82888 Bedienungsanleitung Seite 15

GB
has hardened. Dried construction compound can be diffi cult or impossible to remove. Dried construction compound can damage
the tool. Do not use solvents, alcohols, acids, petrol or abrasives to remove the compound. Having fi nished working, check the
power tool for damage by visually inspecting the exterior and the body and the handle, the functioning of the electric switch, the
vents for clogging, the motor brushes for sparking, the noise level of the bearings and the drive transmission, and how the power
tool starts and runs. During the warranty period, the user is not allowed to disassemble the tool or replace any components or
parts, as this will void the warranty rights. Any irregularities found during overhaul or the operation signal the need for repair at a
service centre. For this purpose, contact the manufacturer. Having fi nished your work, clean the housing, the vents, all switches,
all handles and guards with compressed air (at 0.3 MPa maximum), a brush or a dry cloth. Do not use any chemicals or cleaners.
Do not use sharp tools for cleaning. Remove the circular saw and clean the inside of the guards, the fi xing of the circular saw, as
well as the saw itself from dust and other impurities generated during operation. Clean handles, knobs and other adjusting parts
with a dry, clean cloth.
O R I G I N A L I N S T R U C T I O N S
15