Product Characteristics; Technical Data - YATO YT-82888 Bedienungsanleitung

PRODUCT CHARACTERISTICS

Battery-powered compound extrusion gun allows easy application of adhesives, sealants and other compounds in tubes used in
construction works. A powerful battery and the piston speed control allow you to adjust the extrusion gun to any compound type
and enable faster work and less fatigue than manual extrusion guns. The correct, reliable and safe operation of the tool depends
on its proper use, therefore:
Read and keep the entire manual before the fi rst use of the tool.
The supplier shall not be liable for any damage resulting from failure to comply the safety instructions and recommendations
specifi ed in this manual.
ACCESSORIES
The YT-82888 extrusion gun is supplied with a battery and battery charger. The YT-82889 extrusion gun is supplied without a
battery and battery charger.

TECHNICAL DATA

Parameter
Catalogue No.
Rated voltage
Piston movement speed
Piston movement speed
Piston pressure force
Length of the tube with compound
Diameter of the tube with compound
Weight
Noise level
- Sound Pressure L ± K
pA
- power L ± K
wA
Vibration Level a ± K
h
Protection class
Ingress protection rating
Rechargeable battery type
Battery capacity*
Charger*
Input voltage
Power frequency
Rated power
Output voltage
Output current
Charging time**
* only for models equipped with a battery and charger
** the specifi ed charging time applies only to the battery with the capacity listed in the table
The declared noise emission values have been measured using the standard test method and can be used to compare one tool
to another. The declared noise emission values can also be used for preliminary exposure assessment.
Warning! Noise emissions during the correct operation of a power tool may diff er from the declared values depending on the
manner in which the tool is used, in particular the type of the workpiece.
Warning! Operator protection measures must be determined based on an approximation of exposure under current conditions
of use. All stages of the work cycle must be taken into account. In addition to the working time, other factors must be taken into
account, such as the time when the tool is switched off and when it is idle.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
O R I G I N A L
GB
Unit
[VDC]
[mm/min]
[mm/s]
[N]
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s 2 ]
[Ah]
[V~]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-82888, YT-82889
18
30 - 480
0.5 - 8
2000
255
48
1.3
80.0 ± 3.0
91.0 ± 3.0
1.68 ± 1.5
III
IPX0
Li-ion
4
220 – 240
50 / 60
60
21 DC
2.4
~4
11