Adjusting The Running Speed - F.lli Consonni “Westminster” Bedienungsanleitung

F.lli Consonni
both sides of the dial. Some clock models are equipped with radial switches with small
selectors in the top left and right of the moon phase dial.
Please pick the strike and/or chime lever positions of the one or two selector levers, rods
or radial selectors that apply to your clock and, thus, the possible chime options from the
following table:
Left Side
Mov. APL
(Westminster) K.
<Strike>
<Night Off>
<Silent>
The hour strike and quarter chime (depending on model) mechanisms of your clock can
be operated independently.
When switching from «SILENT» to «STRIKE» the chimes/strike of the movement
families A and S for technical reasons will take between minimal 1 to maximal 2 hours
to
synchronize.
For movements with a single selector lever for the chime and automatic night shut-off,
the night shut-off is activated in the top lever postition («SILENT/NIGHT ON») and
deactivated in the bottom lever position («NIGHT OFF»). Depending on the lever
position used last, the respective chime and the hour strike will then run with or without
the automatic night shut-off.

7. Adjusting the running speed

Depending on model the running speed (timekeeping) of your clock can be adjusted
through the escapement or the pendulum.
Before you make any change, observe and note the timekeeping of your clock over a
longer period of time, for example 12 or 24 hours.
Hour Strike on
Automatic night shut-off
on
Hour Strike off
right side
<Strike>
<Silent>
<Night Off>
<Strike>
<Silent>
<Silent>
<Night Off>
<Strike>
<Silent>
<Whitt.>
<St.Mich>
<Westm.>
<Night Off>
Hour Strike on
Hour Strike off
Automatic night shut-off on
Hour Strike on
Hour Strike off
Hour Strike off
Automatic night shut-off on
Hour Strike on
Hour Strike off
Whittington
St.Michael
Westminster
Automatic night shut-off on
9