F.lli Consonni “Westminster” Bedienungsanleitung Seite 12

F.lli Consonni
12
11.2 Clock does not strike the correct hour
If after several hours of operation your clock does not strike the correct hour, the hour
hand is not positioned correctly.
Grasp the hour hand only and move it forward or backward to line up with the correct
hour on the dial indicated by the number of times the hour strikes.
Rotating this hand independently will not damage the clock.
11.3 Clock will not chime or strike
If your clock does not chime or strike, this can have several causes.
{ If you have just changed the setting of your clock, wait for 1 to 2 hours. The
movement will synchronize automatically.
{ Make sure that the chime selection lever is not in the «SILENT» position or halfway
between two chime melody positions.
{ For models with night shut-off, make sure that the clock is not in the night cycle (see
section 8).
{ Make sure that all the packing material is removed from the movement area.
{ Assure that all springs are sufficiently wound.
{ Check the hammer adjustment and correct as necessary.
11.4 Chimes have unsatisfactory tone
The chime tone of gong rods or bells may be affected by hammers resting on them,
touching insufficiently or striking incorrectly. Although the hammers were set at the
factory, it is possible for them to get out of adjustment during transport.
There are different procedures for adjustment depending on types of chimes:
{ Gong rods: Do not bend or try to adjust the gong rods as they break off easily. The
volume and sound cannot be adjusted on a gong rod. The hammer arms are made of
brass and can be safely adjusted. If necessary, bend the hammer arms so that each
hammer rests approximately 1/8" from each rod. Ensure the hammers do not interfere
with each other while moving. The hammer heads should touch the center of the gong
rods just below the tapering. For adjustment loosen the little screw on the back of the
hammer head and slide the hammer head into the desired position. Securely tighten the
screw afterwards.
{ Bells: The same procedure as for gong rods is applicable. The best bell sound is
achieved when a hammerhead hits the edge of the bell.
11.5 Clock will not run or stops
Although it is not recommended that you repair your own clock, you should check the
following items before contacting your dealer. In any case do not attempt any
adjustment not described in this manual or you do not feel confident in
making.
{ Has all the packing material been removed from the movement?
{ Did you try re-starting your clock (pendulum, only)?
{ Are all springs wound sufficiently?
{ Is the clock standing level and secure?
{ Do all the hands operate without interference?
{ Did you check the suspension spring (pendulum, only)?