Using The Device - Parkside PGG-30 Bedienungs- Und Sicherheitshinweise

Using the device

3. USING THE DEVICE
You can use this glue gun to adhere many
materials and to do many small repair
and decoration jobs in the home. You can
gently glue plastic, cardboard, textiles,
wood, metals and even glass. In addition,
you can get glue sticks at specialty stores
that are made specifically to permanently
glue materials like wood, leather and
ceramics. These special glue sticks
provide even better results.
Before using
Prepare the surface to be glued:
• Do not use any flammable solvents to
clean the gluing surface.
• The ambient temperature, and that of
the material being glued, must be no
colder than +5°C and no warmer than
+50°C.
• The gluing surfaces must be clean, dry
and free of grease.
• Roughen smooth surfaces before
gluing.
• For better adhesion, warm up materials
that cool quickly, such as steel.
• Mount the stand (6) and screw on the
desired glue nozzle (8). Choose the
glue nozzle that gives you the best
access to the gluing surface.
Working with the cord:
1. Connect the electrical cord (11) with
the glue gun's electrical connector (10).
Insert the plug into the electrical outlet.
2. Fold the stand (6) forward. Set the
device down.
3. Insert a glue stick into the feed canal
(1).
4. Allow the device to heat up for about 4
minutes. The device is now ready to
operate.
Working without the cord:
1. Connect the electrical cord (11) with the
28 GB/MT
charging station's electrical connector
(3). Insert the plug into the electrical
outlet.
2. Place the glue gun into the charging
station (4).
3. Insert a glue stick into the feed canal
(1).
4. Allow the device to heat up for about 4
minutes. The device is now ready to
operate.
5. Repeat the preheating phase if the glue
comes out stiff or gooey.
To remove the glue gun from the charger,
press the glue gun forward and remove it
from the charger. (Fig. D)
Gluing:
• Press the feed switch (5) to regulate
the required flow of glue.
1. Apply the glue in dabs. For flexible
materials, such as textiles, apply the
glue in a zigzag pattern.
2. After the glue has been applied,
immediately press the two glued pieces
together for about 30 seconds. The
glued surface reaches full strength in
about 5 minutes.
3. During work interruptions, set the glue
gun on the stand (6) or place it in the
charging station (4).
4. After cooling, remove any remaining
glue with a sharp knife. The glued
areas become loose again if heated.
Turning the device off:
• Pull the plug from the outlet.
Selecting the correct nozzle:
Fig. B
Nozzle 8A: For normal use.
Nozzle 8B: To be used for flat openings
and small areas.
Nozzle 8C: To be used for small holes and
difficult to reach places.