Additional Safety Instructions For Glue Guns; Operation; Before Use; Using The Appliance - Parkside PHP 500 D2 Originalbetriebsanleitung

and are aware of the potential
risks. Children must not play with
the appliance. Cleaning and user
maintenance tasks may not be car-
ried out by children unless they are
supervised.
■ To avoid potential risks, damaged mains cables
should be replaced by the manufacturer, their
customer service department or a similarly
qualified person.
Additional safety instructions for
glue guns
■ Children should be supervised to ensure that
they do not play with the appliance.
■ CAUTION! This appliance must be placed on
its stand when not in use.
■ Always protect the appliance from rain and
moisture. Water entering a power tool will
increase the risk of electric shock.
■ Do not misuse the power cord, e.g. to carry
or hang up the appliance, or to pull the plug
from the socket. Keep cord away from heat,
oil, sharp edges or moving parts. If the power
cord is damaged or severed during work, do
not touch the cord but rather pull out the power
plug. Damaged or entangled cords increase the
risk of electric shock.
■ Only for indoor use.
■ If you take a break of longer than 30 minutes,
pull out the power plug.
■ Allow the appliance to cool completely after
use and before storage.
■ Do not work on any material containing asbestos.
■ Avoid the risk of injury or fire as well as health
risks: RISK OF BURNS! The adhesive and the
nozzle reach a temperature of around 200°C.
Do not touch the nozzle or the glue. Do not
allow hot glue to come into contact with people
or animals. In case of contact with skin, rinse
the affected part in cold running water for a few
minutes. Do not attempt to remove the adhesive
from the skin.
PHP 500 D2
■ Always route the power cable towards the rear,
away from the appliance.

Operation

Before use

Preparing the surfaces to be glued:
■ Do not use flammable solvents to clean the
surfaces to be glued.
■ The ambient temperature and the materials to
be bonded may not be colder than 5°C and
not warmer than 50°C.
■ The area to be glued must be clean, dry and
free of grease.
♦ Smooth surfaces should be roughened before
gluing.
♦ Quick-cooling materials such as steel should be
warmed a little to facilitate adhesion.
♦ Select the desired nozzle

Using the appliance

Mains operation:
♦ Connect the power cable
connection of the glue gun
the power plug into the socket.
♦ Fold down the plastic stand
appliance.
♦ Push a glue stick into the feeder shaft
♦ Allow the appliance to heat up for about
5 minutes. The appliance is now ready for use.

Battery operation:

♦ Connect the power cable
connection of the charger
plug into the socket.
♦ Place the glue gun into the charger
♦ Push a glue stick into the feeder shaft
♦ Allow the appliance to heat up for about
5 minutes. The appliance is now ready for use.
♦ Repeat the heating phase if the glue is still too
thick or viscous.
.
to the mains
(see fig. B). Insert
. Put down the
.
to the mains
. Insert the power
.
.
GB │ IE │
9 ■