Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
General
1.1 Safety
1.2 Responsibility
2.
Pumped fluids
3.
Technical data
3.1 Pump and motor group
4.
5.
6.
7.
7.5 Futher instructions for six-cable
8.
9.
10.1
group
10.2
dismantlement
12. Troubleshooting
1. GENERAL
Read this documentation
carefully before installation.
Installation, electrical connection and commissioning
must be carried out by skilled personnel in compliance
with the general and local safety regulations in force in
the country of installation of the product. Failure to
comply with these instructions not only causes risk to
personal safety and damage to the equipment, but
invalidates every right to assistance under guarantee.
ENGLISH
23
The appliance is not intendend for use by persons
23
(including children) with reduced physical, sensory or
23
mental
capabilities,
23
knowledge, unless they have been given supervision or
23
instruction concerning use of the appliance by a person
23
responsable for their safety. Children should be
24
supervised to ensure that they do not play with the
24
appliance.
24
Ensure that the product has not
24
suffered any damage during
24
transport or storage.
25
Check
27
unbroken and in excellent conditions.
29
1.1 Safety
29
Use is allowed only if the electric system is in
29
possession of safety precautions in accordance with the
29
regulations in force in the country where the product is
29
installed (for Italy CEI 64/2).
30
1.2 Responsibility
30
The Manufacturer does not vouch for correct
operation of the machine or for any damage that it
30
may cause if it has been tampered with, modified
30
and/or run outside the recommended work range or
30
in contrast with other indications given in this
31
manual.
31
31
2. PUMPED FLUIDS
The machine has been designed and built for pumping
31
water, free from explosive substances and solid
31
particles or fibres, with a density of 1000 kg/m³ and a
kinematic viscosity of 1 mm²/s, and chemically non-
32
aggressive liquids.
Small sand impurities of 40 gr./m³ - Ø 1 mm are
accepted.
3. TECHNICAL DATA
3.1 Pump and motor group
The electric pump is a centrifugal multistage pump with
submersible motor and built-in non return valve,
designed to minimize friction losses.
The impellers are dinamically balanced and the shafts
are driven by co-axial bush bearings.
23
or
lack
of
experience
that
the
outer
casing
and
is
Werbung
Kapitel
Inhaltsverzeichnis
