Dräger Polytron 6100 Ec Wl; Conventions In This Document; Meaning Of The Warning Notes; Trademarks - Dräger Polytron 6100 EC WL Gebrauchsanweisung

|
en

Conventions in this document

1.7 Maintenance
– Service the device at regular intervals. The intervals and
activities are defined in the maintenance schedule by the
person responsible for the gas detection system.
Dräger recommends carrying out the following activities
every 6 months:
– Test the signal chain by applying target gas to the
sensor.
– Check the LED display functionality with the Dräger
PolySoft configuration software.
– Service the sensor (e.g., change selective filter).
– Calibrate the sensor (see "Calibration", page 31).
– Observe valid national regulations regarding maintenance
(e.g., EN 60079-29-2, EN 45544-4, T021/T023).
2 Conventions in this document
This document refers to the gas detector Polytron
WL and the repeater Dräger Polytron
The term "gas detector" is used for all contents. Contents
relating to the measuring function apply only to the gas
®
detector Polytron 6100 EC WL.
2.1

Meaning of the warning notes

The following warning notes are used in this document to
notify users of possible dangers. The meanings of the warning
notes are defined as follows:
Alert icon Signal word
WARNING
CAUTION
NOTICE
2.2

Trademarks

Trademark Trademark owner
Aegex Technologies, LLC
TM
aegex10
EX80 Getac Technology GmbH
Bluetooth SIG, Inc.
®
Bluetooth
™ ISA100 Wireless Compliance Institute
ISA100 Wireless
ecom instruments GmbH
®
Pad-Ex
24
®
6100 EC
®
Repeater ISA.
Consequences in case of
nonobservance
Indicates a potentially hazard-
ous situation which, if not
avoided, could result in death
or serious injury.
Indicates a potentially hazard-
ous situation which, if not
avoided, could result in injury. It
may also be used to alert
against unsafe practices.
Indicates a potentially hazard-
ous situation which, if not
avoided, could result in dam-
age to the product or environ-
ment.
Instructions for use
Trademark Trademark owner
PROFIBUS Nutzerorganisation e.V.
®
PROFINET
Siemens Aktiengesellschaft
®
PROFIsafe
The following webpage lists the countries in which Dräger's
trademarks are registered: www.draeger.com/trademarks.
3

Description

3.1

Product overview

Illustration on fold-out page:
A 1 Housing cover
A 2 Battery box
A 3 Protective cap (if battery box removed)
A 4 Connector for antenna with cover cap (delivery state)
A 5 Sealing ring
A 6 Screw plug
A 7 Housing
A 8 Sensing head
A 9 Bayonet ring
A 10 Dummy disk (delivery state)
A 11 Trim plate
A 12 Marking for Bluetooth
magnetic pen use
A 13 LED display
A 14 Set screw (Torx T20)
A 15 Catch-rope
A 16 Fastening screw for catch-rope
A 17 Fastening screw for potential equalization
3.2

Feature description

3.2.1 Dräger Polytron
®
The Dräger Polytron
monitoring toxic gases and oxygen. The gas detector includes
a repeater feature for forwarding data from other
™
ISA100 Wireless network users.
Operation is carried out with a battery pack or a wired power
supply.
The gas meter is integrated into a ISA100 Wireless
with system manager, access point, and controller. The
controller is theDräger REGARD 7000 or a PLC, for example.
Ranges between access point and gas detector are up to 500
m in the free field.
Operation and configuration
The general device status is signaled via the LED display.
®
|
Dräger Polytron 6100 EC WL, Dräger Polytron
®
activation /
®
6100 EC WL
6100 EC WL is a fixed gas detector for
®
Repeater ISA
™
network