Herunterladen Inhalt Inhalt Diese Seite drucken

Intended Use; Start-Up Of The Device/Introduction; Power Supply; Remote Control Batteries - Clatronic mc 1034 cd Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4

Intended Use

This device is used for:
The reception of radio programmes
Playing audio CDs.
It is intended exclusively for this purpose and may only be
used as such. It may only be used in the manner described
in these instructions for use. The device must not be used for
commercial purposes.
Any other use of this device is considered to be contrary to the
intended use and may result in damage to materials or even
personal injury.
The fi rm Clatronic International GmbH does not accept any
liability for damage caused as a result of the use of this device
contrary to its intended use.

Start-up of the device/Introduction

NOTE:
Some keys are to be found both on the device itself and on
the remote control. Keys with the same designation have the
same function.
Read the operating instructions thoroughly before the start-up!
Select an appropriate location for the device, e.g. a dry, fl at,
non-slip surface on which the device can be easily operated.
Make sure that the device is adequately ventilated!
Connect the loudspeakers to the back of the music centre to
the sockets market „Speaker R and L".
Remove the protective fi lm from the display if it is still
present.

Power Supply

Insert the plug into a properly installed 230 V, 50 Hz power
socket.
Please ensure that the mains voltage corresponds to the
information on the type plate.

Remote Control Batteries

Open the lid of the battery compartment on the back of the
remote control.
Insert 2 batteries of type R03 „AAA" 1.5 V (not supplied).
Ensure that the polarity is correct (see the fl oor of the
battery compartment)!
Close the battery compartment.
If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid leaking.
CAUTION:
Different battery types or new and used batteries must not
be used together.
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant
collection bin or at your dealer's.
30
05-MC 1034 CD.indd 30
05-MC 1034 CD.indd 30
WARNING:
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fi re. There is a danger
of explosion!
Inserting the Time Power Reserve Battery
The time power reserve is a long-life lithium cell. If there should
be a power cut or the mains plug of the device is removed from
the socket, the correct time is retained if the power reserve
battery is inserted.
Open the battery compartment on the rear of the device.
Replace the cell by a battery of the same type (CR 2025).
Ensure correct polarity.
Then close the battery lid.
If the device is not used for a long period of time, remove the
batteries to avoid the spilling of battery acid.
CAUTION:
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant collection
bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fi re. There is a
danger of explosion!
Keep batteries away from children. They are not a toy!
Do not open the batteries by force.
Avoid contact with metallic objects. (Rings, nails, screws
et cetera.) There is a danger of short-circuiting!
As a result of a short-circuit batteries may heat up consi-
derably or even catch fi re. This may result in burns.
For your own safety the battery poles should be covered
with adhesive strips during transport.
If a battery leaks do not rub the liquid into your eyes or
mucous membranes. If hands come into contact with the
liquid they should be washed thoroughly and eyes rinsed
out with clear water; if symptoms persist please consult a
doctor.
Setting the Time (in standby mode)
Keep the TIMER SET button (17) pressed down.
Press the HOUR button (16) in order to set the hours. Keep
the button pressed down until the desired hour is reached.
Press the MIN button (15) in order to set the minutes. Keep
the button pressed down until the desired minutes are
reached.
The time is stored automatically.
NOTE:
The time is a 12 hour display.
AM = in the morning; PM = in the afternoon/evening.
05.02.2008 14:43:34 Uhr
05.02.2008 14:43:34 Uhr

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis