Intended Use; Start-Up Of The Device/Introduction; Power Supply - Clatronic SRR 828 Bedienungsanleitung

16 VOLUME (volume control)
17 FUNCTION Function selector switch
(RADIO / OFF/TAPE / CD/MP3)
18 AC Mains connection
19 MODE button (repeat/random / memory)
20 I button (reverse search)
21 I button (forward search)
22 POWER control lamp
23 LCD display
24 FM.ST control lamp
25 II button (Play/Pause)
26  button
27 ALBUM button (album upwards)
28 Loudspeaker
29 Cassette compartment

Intended Use

This device is used for:
• The reception of radio programmes
• Playing back/recording audio cassettes
• Playing back audio/MP3 CDs.
It is intended exclusively for this purpose and may only be used
as such. It may only be used in the manner described in these
instructions for use. The device must not be used for commer-
cial purposes.
Any other use of this device is considered to be contrary to the
intended use and may result in damage to materials or even
personal injury.
The firm Clatronic International GmbH does not accept any
liability for damage caused as a result of the use of this device
contrary to its intended use.

Start-up of the device/introduction

• Please read the operating instructions carefully before using
the device for the first time!
• Select a suitable location for the device, such as a dry, flat,
non-slip surface on which it is easy to operate the machine.
• Ensure that the device is sufficiently ventilated!
• Remove the protective film from the display if it is still
present.

Power Supply

• Connect the power cable supplied (see battery compart-
ment if necessary (4)) to a properly installed 230 V / 50 Hz
safety power socket and the mains connector AC~ (18) on
the back of the machine.
• Ensure that the voltage is the same as that indicated on the
model identification plate.
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment (4) on the bottom.
• Insert 6 batteries of type UM2/R14 1,5V. Please ensure that
the polarity is correct (see the floor of the battery compart-
ment)!
05-SRR 828.indd 31
• If the device is not used for a long period of time, remove the
batteries to avoid the spilling of battery acid.
• Then close the battery lid.

NOTE:
When a mains cable is connected the batteries are automati-
cally switched off.
CAUTION:
• Different battery types or new and used batteries must not
be used together.
• Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant
collection bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fire. There is a danger
of explosion!
Transport Safety Device, CD Compartment
• Open the CD compartment (5) by pulling the lid upwards by
the tab (9).
• Before operating the machine for the first time, remove
the transport safety device from the CD player if it is still in
place.
Volume
The desired volume can be sent using the VOLUME / regulator
(16).
Switch-off
The machine is switched off when the function selector switch
(17) is turned to the OFF/TAPE position.
AUX IN socket
To connect analogue replay devices. Via this socket you can
also hear the sound of other playback devices such as MP3
players, CD players etc. through the loudspeakers.
1. Please connect the external device with a 3.5 mm stereo
jack plug to the AUX IN socket (3).
2. Turn the function selector switch (17) to the OFF/TAPE posi-
tion. Press  button (11) in order to turn the device to
PLAY
AUX IN mode. The cassette sound is switched off.
3. Through the loudspeakers you can hear the playback of the
sound from the external device; with the VOLUME control
(16) you can change the volume. The CD buttons do not
have any function.
4. For the remaining procedure please see the operating
instructions of the external sound source.

NOTE:
Adjust the volume of the external device to a comfortable level.
Unplug the device.
31
08.06.2010 9:53:18 Uhr