Crawlers Replacement; Extraordinary Maintenance; Machine Dismantling; Spare Parts - Fort MECH 35 Bedienungs- Und Wartungsanleitung

FRANÇAIS
able to swing about 3 cm as shown in the figure 8). Once
this condition has been obtained, lock the nuts 2 fig. 6 to
prevent the screws from working loose.

5.3.5 CRAWLERS REPLACEMENT

(Reference to Fig. 8).
This operation shall be performed when the crawlers are
too much worn
WARNING
To replace the crawlers, it is necessary to make sure
that the engine is shut-off, and have the machine
rest on the inner part of the crawlers on a raised firm
ground and perform the following instructions:
Unloose the nuts 2 and the screws 1 until the support 3
and the track tightening wheels 4 retract and rest on the
chassis.
Remove the tracks from the driving wheel 5 and then
from the machine
Insert the new tracks so that they fit on the driving wheels
5 and on the track tightening wheels 4 (make sure that
the teeth match the central pitches inside the tracks) so
that once they are tightened they remain taut.
Tighten the track by screwing in track tightening screws
and once the correct tension has been obtained, lock the
screws in place with the nuts.

5.4 EXTRAORDINARY MAINTENANCE

The operations of extraordinary maintenance are not men-
tioned in this manual: however, they shall be performed
only by the Manufacturer or by skilled personnel authorized
by the Manufacturer himself.

5.5 MACHINE DISMANTLING

In case you decide to dismantle the machine, you shall
separate its components in equal parts which must be
disposed one by one in compliance with the local regula-
tions concerning waste disposal.
Dispose the exhausted lubricants and the several deter-
gents, according to their different structure.
WARNING
For the disposal of the several components, contact
exclusively legally authorized companies that may
issue a regular receipt of the disposal.

5.6 SPARE PARTS

The spare parts of the engine unit must be directly re-
quested to the engine manufacturer or its dealer.
In order to request the spare parts of the machine, contact
the local Dealer of the Manufacturer.
We finally remind you that the Manufacturer is always
at your disposal in case you need after-sale service
and/or spare parts.
33