Initial Use; Operation; Using The Eco Function (Water Saving Effect); Replacing The Cartridge - Miomare IAN 307238 Montage-, Bedienungs- Und Sicherheitshinweise

corresponding hose mounts in the tap body
Under no circumstances should you use tools
to screw the connecting hoses
Make sure that the connecting hoses
running straight and are not being clamped.
Ensure that the base ring seal
correctly in the corresponding nut.
Position the base ring
that it encircles the mounting hole for the tap
and the seal rests on the sink.
Guide the installed connecting hoses
through the base ring
hole and place the tap body
ring.
Guide the fastening nut
sealing ring and if necessary the plastic
15
triangle over the connecting hoses starting
12
from the bottom. When using the plastic triangle
ensure that the flat side is facing upwards so
that it lies directly on the underside of the sink
unit when installed.
Fix the tap to the sink unit by hand-screwing the
fastening nut
into the tap base from below
11
until it stops.
Screw the connecting hoses onto the corner
valve on your wall connection.
Make sure that you attach both connecting hoses
correctly to the hot or cold water connections.
After successfully installing the product, turn on
the hot and cold water supplies.

Initial use

After the first use, carefully check all connections
for leaks. In order to remove any possible impuri-
ties, the tap must be flushed before the first use.
To do this, proceed as follows:
Unscrew the aerator housing
and the aerator seal
20
in an anti-clockwise direction (see chapter
1
„maintenance and cleaning").
Open the main water supply and allow the
water to flow for two minutes to flush out any
residues.
26 GB/MT
18
into the tap.
1
are
1
is positioned
16
on the sink unit so
17
1
into the the mounting
17
onto the base
18
, the washer , the
11 14
, the aerator
19
from the tap spout
21
. Then screw the aerator housing
and the aerator seal
20
spout in a clockwise direction.
1

Operation

Tilt the tap lever forward or press it backwards
to regulate the strength of the water flow.
Turn the tap lever
anti-clockwise direction to regulate the temper-
ature of the water flow:
For cold water, turn the tap lever
wise (to the right).
For hot water, turn the tap lever
(to the left).
To clean the aerator
housing in an anti-clockwise direction and
19
remove the aerator
. Clean any limescale from the aerator and
21
then screw the individual parts back together.
Using the Eco function
(water saving effect)
The cartridge in this tap has an Eco function. When
you move the tap lever
resistance.
The Eco function limits the water flow to 6 l/min.
This allows you to save up to 50% more water.
Tilt the tap lever
resistance.
To increase the flow rate, exert slight pressure
on the tap lever
resistance.

Replacing the cartridge

Cartridges are wearing parts that must be replaced
at regular intervals depending on the lime content
and contamination levels of the water. If the tap le-
ver becomes stiff to operate, this can be a sign that
the cartridge must be replaced. Replacement car-
tridges can be obtained directly at the specified
service point.
, the aerator
19
back onto the tap
21
in either a clockwise or
8
anti-clock-
8
clockwise
8
, unscrew the aerator
20
from the aerator seal
20
, you will notice a slight
8
until you notice a slight
8
until you overcome the
8